LILO start message
- - - - - - - - -

When LILO loads itself, it displays the word "LILO". Each letter is printed 
before or after performing some specific action. If LILO fails at some 
point, the letters printed so far can be used to identify the problem.
This is described in more detail in the technical overview.

Note that some hex digits may be inserted after the first "L" if a 
transient disk problem occurs. Unless LILO stops at that point,
generating an endless stream of error codes, such hex digits do 
not indicate a severe problem.

  ({nothing})  No part of LILO has been loaded. LILO either isn't
installed or the partition on which its boot sector is located isn't active. 

   L {error} ...   The first stage boot loader has been loaded and
started, but it can't load the second stage boot loader. The two-digit error 
codes indicate the type of problem. (See also section "Disk error 
codes".) This condition usually indicates a media failure or a geometry 
mismatch (e.g. bad disk parameters, see section "Disk geometry").

   LI   The first stage boot loader was able to load the second stage
boot loader, but has failed to execute it. This can either be caused by a 
geometry mismatch or by moving /boot/boot.b without running the map installer.

   LIL   The second stage boot loader has been started, but it can't
load the descriptor table from the map file. This is typically caused by
a media failure or by a geometry mismatch. 

   LIL?   The second stage boot loader has been loaded at an incorrect 
address. This is typically caused by a subtle geometry mismatch or by 
moving /boot/boot.b without running the map installer.

   LIL-   The descriptor table is corrupt. This can either be caused by
a geometry mismatch or by moving /boot/map without running the map 
installer.

   LILO   All parts of LILO have been successfully loaded.

* Procuro alguem pra traduzir isso daqui porque ainda nao sou bom ! :)